MX5 Donor, Using as a Donor/problems/solutions/advice Info

[Stot]

Originally Posted by Davidbolam

Johno I have just measured mine and its 285 mm (to the back of the front cross member). I don't know how the engine could go any further back.

I might wait until you have chopped your bonnet to see that is like.

If you removed the flange without cutting the top would it fit?

David

I dont know the measurements because I stripped back to the chassis yesterday for painting but this photo shows how far back my engine is. The clutch rubber is in line with the upright.



I have my engine a bit further to the passenger side which gives me steering rack and inlet clearance. I'm using the Equinox bonnet and it fits without cutouts.



Cheers
Stot