A build update... with a few Q's

[spud69]

Originally Posted by jasongray5

Apparently if you do need to get it apart, then you just need to slide a razor blade between the 2 surfaces, a right bitch to do so im informed tho...?

You can get the extending craft knifes from B&Q or much cheaper at a local pound shop where the blade extends about 4", usually snaps off every 1/2" to give a new sharp edge, but these make it much easier to split the seal.

Could just use 4mm bolts with washers and butterfly nuts and get some nice edge trim from cbs:

http://www.cbsonline.co.uk/rubber-p-...pi2-3527-p.asp

works a treat and finishes it off nice.

AndyH